Einhell TC-TS 2225 U tafelzaagmachine 254mm heeft als beoordeling
3.6 van de
5 door
18.
Rated 5 van de
5
door
Kraan uit
Uitstekend resultaat, staat solide!
Werkt uitstekend, staat stevig op zijn poten, aansluiting stofzuiger werkt top!
Datum plaatsing: 2022-07-25
Rated 5 van de
5
door
AdBe uit
Prima zaagtafel
Het is geen professionele tafelzaag, maar voor de doehetzelver zeker een perfecte machine.
Datum plaatsing: 2022-06-14
Rated 1 van de
5
door
Chipper66 uit
Poor table saw
Mine was clearly a returned item boxed up and sent out again. Came scratched and a piece broken. Looks cheap with the amount of plastic parts. Doubt it would take much use for long . Blade raising handle very poor quality
Datum plaatsing: 2022-05-05
Rated 4 van de
5
door
Gravediggerdan uit
Bargin for the price
For the price it's an absolute bargin. I was going to get an even cheaper one but I really wanted the fence to clipped on both sides and this was the cheapest I could find at the time . The fence clips on fine and holds the ripping wood pretty well ( I've cut down around 30 1200ml long 70x70ml to 50x50ml and it handled it like a champ (you can move the fence with a knock when it's clipped) Mitre gauge is not great to be honest plenty of play involved. (Use a mitre saw if you have one) if not I think you'll be able to buy a better quality mitre gauge. I did cut some 45 degree angles and they were too bad... From opening the box to machine ready is bit of nightmare but bareable (you thought ikea was bad) should have it ready with one to two hours. Use your own socket set trust me. Other than them problems it's a good quality machine and cannot fault it so far barring the mitre gauge. Just spend that little bit more money and get a saw with a fence that clips both sides!
Datum plaatsing: 2022-03-26
Rated 1 van de
5
door
David J R uit
Einhell table saw
I bought this saw after my old Delta table saw gave up the ghost. I use the saw for general diy woodworking but particularly for cutting mitres using a sled that runs on the guides on the table saw top. I then make frames for my paintings for exhibition. Making frames this way has been successful up to now!
My new saw arrived in a battered box with lots of sellotape around it.
On unpacking I discovered the support for work was distorted, having almost certainly been dropped. However, since this doesn’t effect the use of the saw I persevered.
The instructions are practically useless. The blade will not cut at 90 degrees and the knob to hold the blade in position doesn’t hold.
I would not recommend this saw to anyone.
Datum plaatsing: 2022-03-13
Rated 5 van de
5
door
Phil G39 uit
Great performance from a reasonably priced saw
I have to say I was seriously impressed with this saw… when it eventually arrived. It was fairly straightforward to assemble although the instructions aren’t the best and it made accurate cuts when ripping 8’x4’ sheets.
Next day delivery didn’t quite go according to plan, it took 4 days and a couple of phone calls to find out what was happening with delivery
Datum plaatsing: 2022-03-09
Rated 5 van de
5
door
Nivek 50 uit
Very true cut
Its a good diy selfer saw.i was very disappointed with the way it was delivered .the box was soaked as if it had been left out in the rain the machine was a bit battered and bruised but not broken.i have used and its very true cut
Datum plaatsing: 2022-03-09
Rated 1 van de
5
door
Peter snellen uit
Einhell zaagtafel beschadigd
Zaagtafel was helemaal beschadigd aangekomen.. dus terug gestuurd..
Datum plaatsing: 2022-03-08